Savent Strong 1kg is a next-generation concentrated powder for the non-mechanical removal of soot and resinous deposits in chimneys and solid fuel appliances. The catalytic action of the agent is aimed at breaking down soot and resin and converting them into ash, some of which is expelled through the chimney, while the rest settles at the bottom of the combustion chamber. Thanks to its properties, Savent Strong contributes to increased efficiency, extended service life of the chimney and boiler or fireplace, fuel savings of 10 to 20 percent, and a reduced risk of chimney fires. The agent is intended for cleaning brick and metal chimneys, solid fuel boilers, stoves, fireplace stoves, and open and closed-type fireplaces.
Application: Heat the heating appliance and let it warm up. After an hour of burning fuel, add the agent to the burning fire at a rate of 1 measuring spoon per 10 kg of fuel. For convenience, you can sprinkle the agent on paper, roll it up, and throw it into the fire. The amount of powder is determined individually and depends on the moisture content and type of wood, the thickness of soot and resin in the chimney. Keep in mind that a dirty chimney and wet wood may require more powder.
The effect of the application will be noticeable after the first use. For complete chimney cleaning, it is recommended to add Savent Strong each time you load fuel. Continued use of the agent every 4-5 fuel loads will prevent the formation of soot and resin deposits on the chimney walls.
Attention! Sprinkle the powder so that it does not spill from the combustion chamber through the grate.
Warnings: Do not use the agent when there is no draft in the chimney. If the chimney has never been cleaned or the draft is very weak, check the draft for the first 5 uses of the agent, as the soot and resin that falls down can clog the chimney.
It is forbidden to use more than 2 measuring spoons of the agent per 10 kg of fuel, as this can lead to a significant increase in combustion temperature and soot ignition in the chimney.
Avoid contact with eyes and skin. When working with the agent, it is recommended to use gloves and protective goggles. If the agent comes into contact with the eyes, rinse them with warm running water. If irritation persists, seek medical attention (it is advisable to have the agent label with you). After contact with the skin, rinse the skin under running water with soap.
Composition: Copper (II) chloride, calcium chloride, sodium sulfate, ammonium salts, functional additives.
